www.vanco1.com
800-626-6445
6
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
3. Connect a single Category 5e/6/7 up to 196ft/60m to the UTP output of the Transmitting unit, and the
other end to the UTP input of the Receiving unit.
4. For power, plug in both Transmitting unit or Receiving unit with the included power supplies.
5. Power on each device in the same sequence (receiver and transmitter will already be powered when either
unit is plugged in.)
At this point the display connected should display the source signal connected to the extender
set. If no signal is being displayed, connect a shorter Cat5e/6 cable (jumper or patch cable). If a
display is having difficulty receiving a signal, access the display’s menu and adjust the resolution
(lowest to highest until signal is displayed). A 24 Hz vertical refresh rate may work better than
60 Hz or higher. Use the source remote at the receiver emitter to test IR functionality. If the IR
remote function is not responding, check the emitters to ensure they are placed correctly and are
plugged into the correct IR jacks on the Extender set receiving and transmitting units.
