INSTRUCTIONS FOR USE
Battery Level Checking
Under the power-off state, press the Battery
Button (J) to observe the remaining battery
capacity through the Battery Indicator LED (C).
The LED will turn off if the Battery Button (J) is
pressed again or no other operation is performed
within 10 seconds.
Charging Mode
The EPEQ
™
WELDER140 has been equipped with a
built-in charger. So the user only needs to connect
the welder to AC power with rated input voltage
through the charging cable, when the power level is
low. At this time, the Digital Display (B) shows “SC”
(Standard Charging), and the Battery Indicator (F)
shows that it is charging.
Introduction to Charging Mode
Two charging modes are available for the
EPEQ
™
WELDER140: Standard Charging (SC)
and Quick Charging (qC).
Standard Charging Mode
This mode is automatically activated when the welder is connected to AC power. The Battery
Indicator (F) flashes red. The Digital Display (B) will show “SC” (Standard Charging Mode), and
the standard charging time is about 3 hours.
Quick Charging Mode
Press the Battery Button (J) for 2 seconds, and it will switch to the quick charging mode. The cycling of
Battery Indicator (C) speeds up and the Digital Display (B) will show “qC” (Quick Charging Mode). The
quick charging time is about 1.5 hours. Press and hold the Battery Button (J) for 2 seconds to switch back
to the standard charging mode.
Note:
•
Standard charging mode is recommended as this mode optimizes the battery
charging power and maximizes the battery life.
• When the battery capacity is charged to 90%, it will automatically jump to standard
charge mode. At this time, the charging indicator flashes yellow and then turns
green when it is fully charged.
• After it is fully charged, please unplug the charging cable.
• Charging is automatically disabled after 8 hours.
Standard Charging
Quick Charging
2s
Low Capacity
20% Capacity
40% Capacity
60% Capacity
100% Capacity
80% Capacity
2s
