Vanair 050817, Руководство по эксплуатации и список запасных частей

Страница: 83 / 184

AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090019-OP_r0 PAGE - 61
6.4 REPLACEMENT PARTS
Replacement parts should be purchased through your
local Vanair
®
representative or where the 200 Series All-
In-One Power System was purchased. If, for any reason,
parts are not available in this manner, they can be
purchased through Vanair directly.
VANAIR MANUFACTURING, INC.
10896 West 300 N.
Michigan City, IN 46360
Telephone: (800) 526-8817
(219) 879-5100
Service Fax: (219) 879-5335
Parts Fax: (219) 879-5340
Sales Fax: (219) 879-5800
www.vanair.com
6.5 PARTS REPLACEMENT AND
ADJUSTMENT PROCEDURES
System Component or
Part Group Task
Manual
Section
Location
Parts Replacement and Adjust-
ment Procedures
6.5 page 61
Compressor Air Filter 6.5.1 page 63
Compressor Air Filter Replacement 6.5.1.1 page 63
Compressor Oil Maintenance 6.5.2 page 65
Compressor Oil Change 6.5.2.1 page 66
Unloader Valve Maintenance 6.5.3 page 66
Low Pressure Valve Maintenance 6.5.3.1 page 67
Low Pressure Valve Replacement 6.5.3.2 page 69
High Pressure Valve Maintenance 6.5.3.3 page 70
High Pressure Valve Replacement 6.5.3.4
page 71
Compressor Head Valve Assembly
Inspection and Maintenance
6.5.4 page 72
Remove Valve Package 6.5.4.1 page 74
Assemble Valve Assembly Package 6.5.4.2 page 75
Continued on next page
WARNING
Relieve pressure from the compressor
system before removing any
components. The compressor and
engine oil levels should be checked with
the unit shut down and the oil allowed to
properly settle.
NOTE
For assistance when ordering new
replacement parts, consult Section 9.1,
Parts Ordering Procedure , and Table 9A:
Recommended Spare Parts List.
WARNING
Before performing maintenance or repair
operations on the machine, ensure that
all power has been removed and locked
out to prevent accidental start-up.
NOTE
If additional spare parts are being stored
for future use, make certain that they are
stored in proper containers that allow for
protection against contamination, and
kept in a clean area of moderate
temperature reading. For information on
storing the machine package for periods
of non-use, consult Section 6.7.2, Long
Term Storage .