Van Weelden Royal Overdrive, Руководство пользователя

Страница: 7 / 8

(11):
Power input connector
To run the Royal Overdrive you need a 9 to18VDC power supply. (See the amperage specs
at the end of this manual)
The inner pin is negative and the outside of the plug positive.
You can find the specification for the connector and the power consumption in the
specifications section of this manual.
(12): INPUT
This ¼” phono jack is the instrument input for your Royal Overdrive.
Plug the output of your guitar - or the effects you want to have in front of the Royal Overdrive
– into this input with a good quality shielded cable. The Royal Overdrives input is really
sensitive and can pickup noises that can penetrate thru the shielding of a poor quality cable
and will be audible in the end result.
(13): OUTPUT
This ¼” phono jack is the output of your Royal Overdrive. You can plug this output into your
host amplifier or any other device you would like to send it to on your pedal board. In case
your host amplifier preamp stage fails you can hook up the Royal Overdrive output to the
return of an effects loop or power amp input and finish your show!
Please make sure that you always use good quality cables for the best performance. If you are
using very long cables from your guitar to the Royal Overdrive you will notice that there will
be a slight high frequency roll off. If you like a bright sound you must not take a very long
cable if not necessary, but hey… Hendrix, SRV, VH all had long cables and didn’t we all like
their sound?
(14): ON /OFF
This momentary switch will turn on your Royal Overdrive and will be reset to “off” when
power is disconnected.
(15): MIDBOOST
This latching switch will engage the midboost function of your Royal Overdrive and will not
be reset after the DC power is disconnected. It will give you a more focused midrange and
adds some extra gain.
(16): Pilot light
This lamp will light up when the Royal Overdrive is switched on by the on/off switch (14)