Installation manual
Valk
Box
3
Step 1: Mounting the clevis
Step 2: Mounting the curved supports
Depending on the panel width, the clamps B1 and B2
must be positioned inwards or outwards. The correct
orientation for each panel width is shown on the next
page.
Tighten the hinge bolts B1 by hand. These must be
removed temporarily at step 4.
Tighten the hinge bolts B2 firmly, with a tightening
torque of at least 9 Nm, until there is no more play.
The curved aluminum supports are suitable for
panels with a width of 926 - 1150 mm.
A
A
A
A
B1
B1
B2
B2
Tightening torque
at least 9 Nm.
