VAN DER ENDE Verti-Fan EC, Руководство пользователя

Страница: 16 / 28

Page 16 of 28
5 COMMISSIONING
This chapter describes the different electrical wirings that can be used to operate the FG035 fan. The
chosen connection determines the functionality of the Verti-Fan.
Annex B depicts a more comprehensive wiring scheme of the FG035 fan, including the connection
diagram for the 0-10 V control option.
5.1 Operating on basis of supply voltage
The FG035 is delivered with an extra cable. When this cable is connected (as shown by the red line in
Figure 8) in between the E1 socket and 10V socket, the fan will be turned off/on when it receives a
supply voltage. This cable needs to be connected before installation by the installer.
Connect the line voltage to: PE, L1, and N. Here, it must be strictly observed that the line voltage lies
within the allowable tolerance specifications (see technical data).
Figure 8 Wiring scheme FG035 fan
Proceed as follows:
• Remove terminal box cover;
• Insert and connect cables properly and ensure tightness of the cable glands;
• Connect the supplied cable between the E1 and 10 V sockets (see figure 8);
• Close the lid again carefully before start-up (tightening torque for lid screws 1.7 Nm);
Screw terminals
• Nominal torque: 0,8 Nm
• Stripping length: 7 mm +/-0,5mm
• Clamping range
o
rigid : 0,75…6mm 2
o
flexible l: 0,75…4mm 2
o
18...12AWG