www.valuehobby.com/aviator-trainer-25-arf.html
9
Step8. Thread a clevis to the aileron servo pushrod
(
Φ1.8x150mm (6.0inch)), and connect the
clevis to the control horn.
Step9. With the pushrod wire is 90-degrees to the
hinge line and holes in the control horn aligned
with the hinge line, use a drill bit to drill the
mounting holes for control horn.
Step10. Install the control to the aileron using two
M2*16mm screws and one backplate.
Step11. With the control surface centered, tighten
the screw to secure the pushrod to the servo arm.
Step12. Repeat steps 1 through 11 to install the
remaining aileron servo & linkage.
Section3. Wing Installation
Step1. Use epoxy to glue the wing joiner into the
wing panels. Apply epoxy in the joiner pocket, all
sides of the joiner and the exposed wood on the
root rib. Start with one panel; insert the joiner,
then the opposite panel.
(Note: because the wing has dihedral, don’t insert
the joiner in the wrong direction.)
Step2. Use low-tack tape to make sure the panels
fit tightly together while the glue cures.
