VALTIR Triton Barrier TL-2, Инструкция по сборке

Страница: 14 / 28

www.Valtir.com 13 Revision C February 2023
Deployment and Retrieval
1. A flatbed truck with a low bed is ideal for transporting Triton Barrier
®
. Load the sections
onto the transport truck to stack and position them for the greatest shipping density.
Secure the load before transport.
Note:
Empty sections without pedestals may be stacked up to three high. Empty sections with
pedestals attached may be stacked two high. Filled sections shall not be stacked.
2. Begin deployment at the upstream traffic end of the site and work downstream. Work
from the non-traffic side of the deployment whenever possible. Unload the sections
taking care not to damage them. Unloading proceeds much faster if one person remains
on the truck and two people work on the ground. If site conditions permit, a fourth person
can drive the truck so that sections can be unloaded continuously as the deployment is
progressing.
3. If TL-3 kits (Pedestals) are used, attach Pedestals to the barrier using a strap as shown
in Figure 5 and Assembly drawing.
Figure 5
TRITON BARRIER ® TL-3 STRAP