Service and Installation Manual
For warranty service, call 1-888-VALPRO8 / 1-813-502-030
14
Setting Initial Data of Water Filter
If you use a water filter, before usage the unit should equipped with water
filter as follow:
1.
Plug in the unit, press the CLEAN button, the ice machine will run
automatically in Clean mode. The green Clean Cycle LED will be on.
Then press the CLEAN button more than 6 seconds, it begins to clean, and
the Cleaning Recommended Indicator Light will be on. And under any
working status after equipped with water filter, the Cleaning
Recommended Indicator Light will be on.
2.
Then press the STANDBY button to drain out the water, leave the ice
machine in the Stand-by mode. If it proceeds to the ice-making stage,
please press the ICE button to make ice.
NOTICE:
1.
The cleaning recommended indicator light will change from green, yellow
to red according to the consumed water quantity. In the beginning the
Cleaning Recommended Indicator Light is green, followed by yellow.
When the light goes red, it warns you that replacement of a new one will
be necessary.
2.
We recommends you replace water filter for every 6 months. If the
validity of the water filter is earlier than remind lamp, just refers to the
validity of the filter to replace it, and vice versa.
If you do not use a water filter, you needn’t set the initial data of water filter,
and the cleaning recommended indicator light will be off under any working
status.
Operating Method
1.
Turn on the water tap, then press the ICE button, all the indicator lights on
the control panel blinking(Except the cleaning recommended indicator
light
，
the light according to using a water filter or not), the water enter the
water tank.
Service and Installation Manual
15
For warranty service, call 1-888-VALPRO8 / 1-813-502-030
2.
After about 2 minutes, the ice maker will automatically proceed to the
ice-making stage, and the sound of flowing water will be heard. Only the
green ice making indicator light lights. (Except the cleaning recommended
indicator light)
3.
When the batch of ice has been fully formed, ice will automatically fall into
the ice storage bin. The yellow ice harvest indicator light will be on, and
other indicator lights will be off. (Except the cleaning recommended
indicator light)
4.
When the ice storage bin is full, the sheet of cubes will not fall completely
and will hold the magnetism switch open. The machine is in the ice-full
mode, and the red ice full indicator light is lit, and other lights will be off.
(Except the cleaning recommended indicator light)
5.
The unit starts making ice again automatically after ice cubes are removed.
As ice is removed, the magnetism switch closed back to operating position.
Ice-making stage Bin full stage
IMPORTANT:
•
Although the unit has been tested and cleaned at the factory, due to
long-term transit and storage, the first batch of cubes must be discarded.
•
Never turn the water supply tap off when the ice maker is working.
•
Never touch the evaporator when the machine is running.
•
Except to take ice from the unit, keep the door closed to reduce melting and
insure proper ice formation.
Содержание VPIM-420
Страница 2: ......
