START USING THE WIRELESS EARPHONE
1) Charging the wireless earphone
Connect the earphone with car charger to your car’s charging port to charge the earphone.
Fully charge the earphone before using.
Note: Please make sure that the earphone is switched off when charging is in progress.
2) Pairing the wireless earphone (switched off)
Single:
Step 1: Activate Bluetooth function on your mobile device to begin pairing with earphone.
Step 2: Switch on the earphone by long pressing the multi-function button till the LED
indicator flashes blue and red.
Step 3: Connect to the earpiece by selecting ‘Valore BTS20’ under the device list.
Step 4: Once connected, the LED light at the will be solid blue.
If the pairing is not successful, please turn off wireless earphone first, and then re-pair again. After pairing is
successful, paired devices will remember each other. Unless pairing information is deleted because of new
pairing, no need to pair when using the next time.
If you want to pair the wireless earphone with other devices, please turn off Bluetooth function of existing
source device, and pair the wireless earphone with the new device according to steps 1-4 mentioned above.
3) Wireless earphone controls
Answer/End call:
Short press the Multi-function button to answer/end call.
Rejecting a call:
Press and hold the Multi-function button to reject a call.
Redial last number:
Press the Multi-function button twice to redial last number.
Call forwarding:
During a call, press and hold the Multi-function button to forward a call.
Play/Pause music:
Press the Multi-function button once to play/pause music.
Three-Wall calling:
If a call (B) is coming in during an on-going call (A), press the
Multi-function button to release A and answer B. You can also press the
Multi-function button twice to hold A and answer B and press the
Multi-function button twice again to switch between A and B.
Power off:
Press and hold the Multi-function button for about 5 seconds to power off.
Enable/Disabling voice control:
Press the Multi-function button for one second, voice
control is enabled when a buzz sound is heard. Press the
Multi-function button for one second again, voice control
will be disabled.
Sleep mode:
When not in use, put the earphone back to the base. The red LED is on for one
second and the earphone will automatically enter sleep mode.
Intelligent call answering:
When there is an incoming call, take the earphone out of the
base and the earphone will automatically re-connect to your
smartphone allowing you to answer the call.
