9
2.2 Parameters of The Products
Display
Power Consumption: 1300 mW (Regular); 1680mW (Max)
Power Supply: DC 12/24 Volt
Weight: 231g (8.15 oz.)
Dimensions: 15.5 x 6.2 x 2.3 cm (6.1 x 2.4 x 0.9 inch)
Operating Temperature Range: -40°C to 85°C (-40°F to 185°F)
Pressure Resolution: ±0.01Bar (0.1PSI)
Temperature Resolution: 1°C (1°F)
2.3 FCC's authentication announcement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
show
incomprehensible
codes
Values are not
being received at
a tyre location
after a transmitter
was replaced or a
spare tyre was
installed.
The ID number for the
transmitter at that location is
not programmed into the
receiver
Replace the old ID module with a new
one came with the new transmitter.
Restart the system and set baseline
pressure.
(High or low)
Pressure
Warning is
activated at more
or all
transmitter
locations after the
installation is
complete
Didn’t setup the baseline
pressure
Setup the baseline pressure for each
axle
The buzzer is
continuously
chirping and
nothing shown on
the display
The display does not work
Replace the display