2
Casting Tolerances
Due to the nature of cast iron, dimensional consistency
may vary from one unit to the next and some variation
in surface finish and flatness is to be expected. We have
done our best to control and make allowance for this;
however some variation is inevitable.
Wall & Floor Fixing
The President FS can be installed against a wall or in
the room away from walls. The appliance is designed to
be fixed to the floor. The appliance can additionally or
alternatively be fixed to a rear wall. The fixing positions
are shown in figure below. The appliance is approved
for installation directly on wood flooring. If the appliance
is installed directly on carpeting, vinyl tile or other
combustible material other than wood flooring, it must
be installed on a metal or wood panel extending the full
width and depth of the appliance.
Front & Sides Pack
(Box 1)
• 1 Front Casting unit with
Barrier Screen
• 2 Side Casting units
• 1 Top Baffle
• 2 Stand-off Spacers
• 1 Pack of Screws & Washers
Top Pack (Box 2)
• 1 Top Casting
• 1 Top Infill Plate
Kit Contents
Top Baffle
Stand-offs
Spacers (2)
Infill Plate
Top
Casting
Front Casting with
Barrier Screen
Side Casting
Floor Requirements
The 530 heater is approved for installation directly
on any combustible material other than soft flooring
material such as carpet or vinyl.
Mantel Requirements
The President FS may be installed with a combustible
mantel provided clearances are maintained as indicated
in the Dimensions and Clearances. Be aware that
although safe, some combustible materials and finishes
at the listed clearances may, over time, discolor, warp,
or show cracks. Care should be taken when choosing
materials—consult your fireplace dealer.