Valor LEGEND G4 785ILN (NG), Инструкция по установке и эксплуатации

Страница: 17 / 42

Pilot
Burner
screw
Air
shutter
screw
Ceramic Panels Installation
Burner Removal and Reinstall
The following guidelines apply for all panels. You do
not need to remove the burner to install the panels.
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors (one per side)
just enough to allow them to rotate.
2. Place the rear panel against the back of the fi rebox,
on the ledge at bottom, behind the burner.
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the fi rebox side.
Rotate the anchor back down to hold the panel.
4. Rotate the anchor up and out of the way and slide
the right hand side panel against the fi rebox side.
Rotate the anchor back down to hold the panel.
The ceramic panels can be installed without removing
the burner. However, you can remove the burner for
additional space if desired.
1. Remove the 2 screws fi xing the rear of the burner
to the manifold bracket as indicated. Do not remove
the air shutter screws.
5. Tighten the side panel anchors on each side of the
fi rebox.
6. Install the top panel supporting it with the back and
side panels.
7. Discard the front bricks as they are not required on
this fi replace.
2. Grab the burner as indicated and gently pull up the
rear fi rst and then the front.
Be careful not to hook
the pilot hood as you pull the burner up.
3. To reinstall the burner, fi t the burner in the fi rebox
inserting the front fi rst.
Again, be careful not to
hook the pilot hood when fi tting the burner over
the pilot.
Fix the burner to the manifold bracket at
the rear with 2 screws.
17
INSTALLATION