Page 51
©
GDC Group Ltd. NOV 2017
Benchmark Commissioning and Servicing
Section
,WLVDUHTXLUHPHQWWKDWWKHJDV¿UHLVLQVWDOOHGDQGFRPPLVVLRQHGWRWKH
PDQXIDFWXUHU¶VLQVWUXFWLRQVDQGWKHGDWD¿HOGVRQWKHFRPPLVVLRQLQJ
FKHFNOLVWFRPSOHWHGLQIXOO
7RLQVWLJDWHWKHJXDUDQWHHWKHJDV¿UHQHHGVWREHUHJLVWHUHGZLWKWKH
PDQXIDFWXUHUZLWKLQRQHPRQWKRIWKHLQVWDOODWLRQ
7RPDLQWDLQWKHJXDUDQWHHLWLVHVVHQWLDOWKDWWKHJDV¿UHLVVHUYLFHG
DQQXDOO\E\D*DV6DIHUHJLVWHUHGHQJLQHHU7KHVHUYLFHGHWDLOVVKRXOG
EHUHFRUGHGRQWKH%HQFKPDUN6HUYLFH,QWHUYDO5HFRUGDQGOHIWZLWKWKH
KRXVHKROGHU
www.centralheating.co.uk
+HDRW:DWHU,QGXVWU\&+,&
This device incorporates a probe which senses that the heat from the pilot flame is
correct. If this probe is cool, the device will prevent any gas flow unless the control
knob is held in at the ignition position.
If, for any reason, the flames go out when the fire is hot or if the fire is turned off
when hot, always
wait at least three minutes before attempting to relight
.
Basic operations of the fire with the Remote Control Handset.
Reference the remote control handset operation manual for all the features.
-
Setting Fahrenheit or Celsius
- Setting the time / - Child Proof option / - Manual mode (handset)
- Standby mode (Pliot flame) / - Flame height adjustment
- Designated Low fire and High fire / - Countdown Timer
- Modes of operation - Thermostatic mode
- Programe mode
- Eco mode
- Auxiliary feature (Rear burner operation)
Lighting the fire.
Press and hold the ‘ON’ button until a short acoustic signal
confirms the start sequence has begun; release button.
Continuing signals confirms the ignition is in progress. There
will be a slight delay and several sparks should be seen
between the electrode and pilot tip. Once pilot ignition is
confirmed there is main gas flow.
When pilot ignition is confirmed, motor turns automatically to maximum flame height.
Adjusting the flame height.
When the burner is operating press
the UP arrow button to increase the
flame height.
Note:
Flame height can be adjusted
UP on a single burner or when the
two burners are lit at the same time
to get the desired output.
Press the DOWN arrow button to
decrease the flame height.
Note:
Flame height can be adjusted
UP on a single burner or when the
two burners are lit at the same time
to get the desired output.
OWNER GUIDE