Valor HORIZON 535, Инструкция по установке

Страница: 19 / 24

10. SWITCH FITTING
10.1. For wall switch as only active switch
See figures 27, 28 & 29
•
Feed the switch wires from inside the appliance case through the
opening at the bottom right side of the heater case.
•
Route round the back of the valve and connect the two “L” terminals
to the tabs at the left side of the control unit. See figure 27.
•
Connect the battery holder to the black connection pad.
•
If using the switch extension wires, connect the extension to the wire
harness.
Fit the four 1.5 V batteries. Place the battery holder on the “Velcro”
pad in front of the battery shield. See figure 28.
•
•
A standard wall switch box should be secured in the framing to
accommodate the wall switch. If the required location is over 4ft
away from the appliance, an optional #609WEK unit will be required.
•
When fitting the wall plate to the wall box, attach the way up shown
in figure 29 so that pressing the upper half of the switch increases the
flames.
10.2. For active remote control with or without active wall
switch
Caution! Don’t connect the batteries in the remote control receiver until
the wires are connected to the burner control unit. A short circuit could
result in destruction of the electrical components.
Feed the switch wires from inside the appliance case through the opening at
the bottom right side of the heater case.
•
•
•
•
•
•
•
•
•
•
•
Cut off the “L” terminals from the switch wires on the remote control receiver and remove
insulation from approximately ¼” at ends of wires. See figure 30.
Securely connect the wires to the terminal block. Connect the black wire to the terminal
opposite the brown wire. Connect the wire with the white stripe to the terminal
opposite the yellow wire.
See figure 31.
Route the harness wires with the “L” terminals round the back of the valve and connect to
the tabs at the left side of the control unit.
Remove the remote control receiver lid. Remove the cover from the
white connection pad.
Fit this connection pad to the remote control receiver terminals. See figure 32.
Fit the
black connection pad to the battery holder. Fit four 1.5V batteries. See figure 32.
Place the batteries and connection pad in the receiver box and replace the lid.
Fit the 9V battery to the handset transmitter.
Place the remote control receiver on the “Velcro” pad in front of the battery shield. See
figure 33.
If using the switch extension wires, connect the extension to the wire harness.
If using the wall switch, attach the wall plate the way up shown in figure 29 so that pressing the
upper half of the switch increases the flames.
18 of 23
Figure 33 Remote control
reciever position
Figure 32
Figure 31
Figure 30
Figure 29 Wall switch
orientation
Figure 28 Battery position
Figure 27 Switch wires installation
Figure 31 Wall switch - Appliance end