77
Correct Flame
Picture—Rocks
Thermocouple
probe must be
in flame
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Remote Control Handset Wall
Holder
Your
replace equipment includes
a wall holder to store the handset.
If it hasn’t be installed, refer to the
instructions further on in this manual
for the installation.
Batteries
Low battery signal: see page 13.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —
see instructions on
next page.
The appliance uses four 1.5 V AA
alkaline
batteries for
its remote control receiver and one 9 V
alkaline
battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the
rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace batteries with 4 AA
alkaline
batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the
Velcro
tab.
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
replace cool
rst before touching it.
!
Owner’s Information
7.
Replace the front or trim with the barrier screen
attached.
Checks
A periodic check of the pilot and burner
ames should
be made. Check after the
re has been on for at least
30 minutes. The pilot
ame must cover the tip of the
thermocouple probe. The main burner
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Correct Flame
Picture—Logs
Pilot Flame can be seen
between left front and top logs
left of
rst rock
Pilot
ame
Thermocouple
probe must be
in
ame
Rock fuel bed
A black discoloration may form over time at the front
bottom of the 6-rock original fuel bed; this deposit
can be burned off by running the
replace on a low
to medium setting
re for 30 to 45 minutes. This
discoloration is unavoidable and will re-form again.
WARNING
FOR SAFETY PURPOSE, ensure the barrier
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the
fi
replace front
screen is re-installed on the
fi
replace front
after maintenance.
after maintenance.
!
OWNER’S
INFORMATION
