2
Remote Control Operation
Radio Frequency
315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: Before using the remote control system for
the
fi
rst time,
the receiver and the handset must
be synchronized. See the section
Synchronize Remote
Control
.
IMPORTANT:
BEFORE YOU BEGIN, please note that on
this system, the settings of time/temperature
can only be
programmed when the function display is
fl
ashing
.
Be patient when programming as it can take a few seconds
to set.
To communicate, the handset should be within 15 feet
(4.5 meters) of the
fi
replace.
Do not leave the handset on the mantel or hearth.
OFF
(turns the burner
DQGWKHSLORWR
/DUJHȵDPHEXWWRQ
ȵDPHVXS
VHWVKRXUV
6PDOOȵDPHEXWWRQ
ȵDPHVGRZQDQGR
VHWVPLQXWHV
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Handset
sensor
Battery status
Turn Fireplace ON
Press + buttons until you hear a
short beep; release buttons.
Beeping continues until pilot is lit.
NOTES:
On the valve, MAN button must be at
ON, in full counter-clockwise position
.
ON/OFF switch (if equipped) must be in I (ON) position.
Turn Fireplace OFF
Press button.
When pilot is just turned o
ff
, wait 2
minutes to light it again.
Standby Mode (Pilot Flame)
Press and hold to set
fi
replace
to pilot.
Adjust Flames Height
With pilot lit, press and hold buttons:
= increase
fl
ame height
= decrease
fl
ame height or
set to pilot
For
fi
ne adjustment, tap buttons.
Set the di
ff
erent parameters when
they are
fl
ashing.
