Valor GV60 MAX, Руководство по эксплуатации, Страница: 4 / 5

4
Circulating Fan Operation
(if equipped)
Circulating fan has 4 speed levels from
low to high (1 to 4 bars).
Press SET to scroll to . Fan and
level icons fl ash.
To set speed, press fl ame buttons:
= increases speed.
= decreases speed and
turns OFF fan when all bars disappear.
Note: 8 seconds after the fan is set, handset goes
automatically in temperature control mode. Fan
starts 4 minutes after gas opens (from OFF or
pilot) at maximum speed then goes to displayed
level after 10 seconds. Fan stops 10 minutes after
gas is OFF or at pilot.
Setting high / low Temperatures
Setting “DAYTIME” high temperature.
Default Settings:
TEMP
23 °C/74 °F
Press SET to scroll to
TEMP
Hold SET button until TEMP fl ashes.
To set Daytime Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
Setting “NIGHT TIME SETBACK” low temperature.
Default Settings:
TEMP
“--” (OFF)
Press SET to scroll to
TEMP
Hold SET button until TEMP fl ashes.
To set Night Time Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
Setting Program Timers
You can program two periods of time between 12 am
and 11:50 pm in each 24-hour cycle.
Programs P1 and P2 must be set in the following order
during a 24-hour cycle:
P1
,
P1
,
P2
and
P2
.
= Day Time temperature (high) program period
= Night Time temperature (low) program period
Default Settings:
Program 1:
P1
06:00 am
P1
08:00 am
Program 2:
P2
11:50 pm
P2
11:50 pm
Press SET to scroll to
TIMER
.
Setting P1 time - high temperature.
Hold SET button until
P1
is displayed and time
fl ashes.
To set time:
= hour
= minutes
Press or wait to complete setting.
Setting P1 time - low temperature.
Hold SET button until
P1
is displayed
and time fl ashes.
To set time:
= hour
= minutes
Press or wait to complete setting.
Remote Control Operation
If
P1
=
P1
or
P2
=
P2
,
programming is cancelled.
To keep
fi replace ON all night, set
P2
at
11:50 am and
P1
at 12:00 am.
If you want to program only one period,
program
P1
and
P1
with desired times
then
P2
and
P2
with the same time
as
P1
.