Valor GV60 MAX Скачать руководство пользователя страница 1

Страница: 1 / 5

Oct 2019

Synchronize Remote Control

The receiver and the handset of the remote control sys-

tem must be initially synchronized before the

rst use.

1. Insert alkaline batteries in the remote control

battery holder and handset. The battery holder is

located beside the receiver, near the control valve

under the

rebox, left of the

rebox or beside the

wall switch.

2. With a sharp object, press and hold the receiver’s

reset button until you hear one short and one long

beeps. Release the reset button after the second

beep.

Operation Manual

GV60 MAX

GV60 MAX Electronic Ignition Remote Control

For Valor heaters 700, 780, 785, 1000, 1100, 1150 and 1400 installed with or

without a fan (blower)

3. Within the subsequent 20 seconds, press the small

ame button ( ) on the remote handset until you

hear two short beeps con

rming the sychronization

is set. If you hear one long beep, this indicates the

code learning sequence has failed or the wiring is

incorrect.

This is a one time setting only and is not required when

changing the batteries in the remote receiver. The

remote control system is now ready to use.

Содержание GV60 MAX





