OPERATING YOUR FIRE
The Oxysafe flame sensing & flue blockage safety system.
For your safety, this appliance is fitted with a flue blockage safety device which will
shut down the appliance in the event of abnormal flue conditions.
This device is NOT a
substitute for an independently mounted Carbon Monoxide detector.
The device will also automatically shut off the gas supply to the fire if the pilot flame
goes out due to lack of oxygen or for any other reason.
If this device starts to repeatedly shut off the gas, get expert advice.
This device incorporates a probe which senses that the heat from the pilot flame is
correct. If this probe is cool, the device will prevent any gas flow unless the control
knob is held in at the ignition position.
If, for any reason, the flames go out when the fire is hot or if the fire is turned off when
hot, always
wait at least three
minutes before attempting to
relight
.
To light the fire
To get access to the control knob
lower the bottom front cover. To do
this, support the top and bottom of
the lower front cover (See figure 2).
Depress the control knob and
turn anticlockwise towards the
PILOT/IGN position (See figure 3).
A spark should be generated at the
pilot while turning. The spark
should ignite the pilot. The pilot
flame can be seen at the left side of
the pebbles.
Keep the button at the PILOT/IGN position for a further ten seconds. This will prevent
Page 7
OWNER GUIDE
PLEASE NOTE
When operating your fire for the first time, some vapours may be given off which may
cause a slight odour and could possibly set off any smoke alarms in the immediate
vicinity. These vapours are quite normal with new appliances. They are totally harmless
and will disappear after a few hours use.
Figure 2. Lower front cover
