6
Cleaning the coal bed
If for any reason the one piece coal bed requires cleaning,
proceed as follows:-
1.
Remove the case front and window as described
above.
2.
Carefully lift the coal bed out of the firebox and
place it on a piece of cardboard or similar.
3.
Carefully vacuum the upper and lower surfaces of
the coal using a soft brush attachment.
4.
Replace the coal bed in the firebox. Make sure
that the coal bed rests over the locating bracket at the rear
of the fire box and is pushed back so that it touches the
back of the fire box. Lower the front so that the outer
coals rest on top of the two front support brackets (see Fig.
7).
5.
Replace the window unit as described above.
6.
Refit the outer case. Make sure that the sloping
panel at the top front of the appliance interior (convection
strip) is below the top of the outlet in the outer case hood.
(see Fig. 8). This panel guides the warm air into the room.
Fig. 8 Replacing Outer Case Front
Fig. 7 Coal Bed Location
