REMOTE CONTROL OPERATION
The two buttons on the remote control operate in the same way as the manual switch located at the base of the
appliance. Operation of the remote control buttons corresponds to the switching sequence in the above table.
Please note that it takes time for the receiver to respond to the remote control. Do not press the buttons more than once
within two seconds for correct operation.
BATTERY INFORMATION
1. Unclip the battery cover on the back of the remote control. (Fig. 12)
2. Install AAA batteries into the remote control, making sure to orient the positive and negative terminals correctly.
3. Replace the battery cover.
DiscardIing leaky batteries
Dispose of batteries in the proper manner according to national and local regulations. Any battery may leak electrolyte if
mixed with a different battery type, if inserted incorrectly, if all the batteries are not replaced at the same time, if disposed
of in a fire, or if an attempt is made to charge a battery not intended to be recharged.
THERMAL SAFETY CUT-OUT
A thermal safety cut-out is incorporated in the fan heater to prevent damage due to overheating. This can happen if the
heat outlet is restricted in any way or if the chimney flue has not been blocked off effectively. The cut-out operates by
cutting the power to the fan heater if the heater overheats. To restore power to the fan heater, unplug the appliance and
leave it to rest for approximately 30 minutes. Once the temperature in the fan heater has reduced, plug the appliance in
and power it back on. If the fan heater cuts out during operation, remove any obstruction that may be restricting the heat
outlet before carrying out the above steps.
Maintenance
Additional Information
Cleaning
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning, use a soft clean duster - never use abrasive cleaners.
The flame panel should be cleaned carefully with a soft cloth.
To remove any accumulation of dust or fluff, the soft brush attachment of a vacuum cleaner should occasionally be used
to clean the outlet grille of the fan heater.
There is a mirror located underneath the canopy. (Fig. 13) This may require cleaning to ensure a sharp clear holographic
image.
AFTER SALES SERVICE
1 Year guarantee
Your product is automatically guaranteed for one year from the date of purchase. Within this period, we undertake to
repair or exchange this product free of charge providing:
a) Proof of purchase such as a sales receipt can be provided, showing that the appliance was bought within the
12-months prior to registering the defect/fault.
b) The appliance was correctly installed and operated in accordance with the manufacturer’s instructions and used
solely for domestic purposes.
c) The defect/fault was not as a result of accident, misuse, unauthorised modification or inexpert repair.
Consumable parts, such as fuses in plugs and bulbs, which require routine replacement are excluded from the
guarantee.
Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.
Should you require after sales information or assistance with this product please go to
www.valor.co.uk
where you will
find our self help guide. Alternatively, call our help desk on
0844 879 3588 (UK)
or
01 842 4833 (R.O. I.)
.
Spare parts are also available on the website. Please retain your receipt as proof of purchase.
RECYCLING
For electrical products sold within the European Community. At the end of the electrical products useful life
it should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
