maintained (See figure 1).
The heater must not be located under a
fixed electrical socket, the socket must
always be accessible in order to disconnect
the heater from the electrical supply for
maintenance or when replacing a lamp.
Although the stove complies with all
the safety standards, some kinds of floor
coverings (e.g. vinyl tiles, synthetic deep
pile carpets) may be affected by the hot air
from the fan. We suggest in these instances
that you place the heater on a shallow
plinth that projects 150mm forward of the
front feet.
Keep hearthrugs and other soft
furnishings etc. away from the front of the
heater. They could obstruct the free flow of
hot air from the fan and damage both soft
furnishings and heater.
Installation
Before connecting the heater to the power
supply for the first time, it is necessary to
arrange the loose coal on the fuel support
inside the heater.
At the rear of the heater, remove the thumbscrew securing the top panel and slide
backward, remove and put to one side (See figure 2).
Arrange the coal on the support to achieve the desired effect. It is not necessary to
use all the supplied coal.
Refit the top panel by engaging the front edge and slide forward. Secure with the
two screws removed previously.
The socket must always be accessible in order to disconnect the heater from the
electrical supply for maintenance or when replacing a lamp.
Important! This heater must be earthed.
The heater is supplied with a 3 pin 13A fused re-wireable plug with 1mm². 3 core
mains cable,
L = Brown
N = Blue E= Green/Yellow
The mains supply cable must be safely routed from the heater to an electrical
socket. If the mains cable is damaged, to avoid a hazard it must be replaced by a Valor
Page 5
INSTALLER AND OWNER GUIDE
Figure 2. Top panel removal
Figure 1. Side clearance when fitting
into alcove (Shown with Georgian).
