2
NOTE: Where further fixing is required, fasten the
surround to wall using screws through 2 outermost
holes at the top centre of the surround. Backing
or wall anchors (not supplied) may be required for
fastening.
5. The rectangular cap can be fitted to the surround
after the surround is installed. Simply fit the screws
provided to the back of the cap and hook the cap
to the surround through the 2 keyholes at the top
center.
6. Clip the selected trim (supplied separately) onto the
mounting brackets within the cast surround.
7. Finish the front trim installation according to
instructions packed with each trim.
Installation
1. Install the 738 or 739 heater as per installation
instructions packed with the heater.
2. Install 2 mounting brackets (supplied with heater)
to the back of the cast surround using the machine
screws provided.
3. The surround comes with a choice of 2 decorative
caps to be fitted at the center of its top section.
If the round cap is chosen by the customer for this
installation, insert the tapped stud provided from
the back of the surround through the center hole.
Fit the nut provided on the stud. Screw the cap to
the stud. If the rectangular cap is chosen for this
installation, see step 5. below.
4. Install the cast surround fitted with mounting
brackets to the heater using 4 screws provided.
Fasten Brackets
(supplied w/heater)
to back of surround
using screws provided
Fasten surround
and brackets to
heater using
4 screws
Wall Fixing Points
Rectangular Cap Fixing Points
Round Cap
Fixing Point
Adjust screws length
to tighten or loosen
cap fitting
