Valor 650JLN, Руководство пользователя

Страница: 7 / 52

77
Rock fuel bed
A black discoloration may form over time at the front
bottom of the 6-rock original fuel bed; this deposit
can be burned off by running the
fi replace on a low
to medium setting fi re for 30 to 45 minutes. This
discoloration is unavoidable and will re-form again.
Owner’s Information
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
!
Correct Flame
Picture—Rocks
Thermocouple
probe must be
in flame
Correct Flame
Picture—Logs
Pilot Flame can be seen
between left front and top logs
left of fi rst rock
Pilot fl ame
Thermocouple
probe must be
in fl ame
WARNING
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the
fi replace front after
maintenance.
!
Safety warning plate
7. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
8. Replace the front or trim with the barrier screen
attached.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and free
from combustible materials, gasoline and other
fl am-
mable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
Low battery signal: see page 13.
BEFORE changing the batteries, turn off the valve
using the wall switch’s On/Off button
.
The appliance uses four 1.5 V AA alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the fi rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the batteries with 4 AA
alkaline batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in
so it attaches to the
Velcro
tab.
OWNER’S
INFORMATION