2
Install Appliance with 1430 Fixed Framing Kit
The side brackets provided loose with the appliance
are not needed with this kit.
Hearth considerations
You need to know whether there will be a hearth or
not in front of the appliance and some rules must be
considered:
Without hearth
In the case where there is no hearth, the bottom of the
appliance must be raised at least 4” inches above any
combustible fl oor in front.
With hearth
Any hearth within 4” vertical of the base of the heater
must be non-combustible. See
Hearth Requirements
section of the manual packed with the appliance.
Section view, up the wall—detail
Section view,
hearth—detail
Lower panel
Removable panel
1-1/8”
(29 mm)
Front of
appliance
Stud
Plywood base
Appliance base
Lower panel
Removable panel
Finishing up the wall
Stud
Plywood
base
Appliance base
Lower panel
Removable panel
Finishing with hearth
Non-combustible
material
1/2” insulating
Micore
panel
(supplied with appliance)
Plywood
sub-floor
1-1/2” (38 mm)
max. thickness
(including
Micore
)
Appliance base
1/2” combustible
shim at ends to
match
Micore
Lower panel
Removable panel
1-1/2” (38 mm)
Front of
appliance
Plywood
Appliance base
