INSTRUCTION MANUAL
PLL FM Stereo Transmitter
Model No:ACC-FMT7
BEFORE INSTALLING THE TRANSMITTER
Do not install the unit in the following locations.
Locations exposed to direct sunlight.
Where hot air is discharged from the car heater.
In areas subject to extreme temperatures.
INSTALLATION
The FM Stereo Transmitter must be mounted within 24
inches of your radio so that its power cable
can reach the radio power antenna lead.
The FM Station Frequency Selector Switch is located
on the face and you may wish to change it after your
initial checkout or sometime in the future.
FM RADIO FREQUENCY PRESET
The FM Stereo Transmitter can operate on from87.7MHz to 88.9MHz.
(7channel-200KHz Step)
The Frequency Selector Slide Switch is on one channel of the
Transmitter and was set 87.7MHz at the factory. Assuming it is still
there, turn on the car stereo and select FM band operation. Tune
the radio to 87.7MHz(depending on frequency to which you
have set the unit), or push the pre-set memory button.
FM RADIO FREQUENCY PRESET
INTERFERENCE ON 87.7MHz;
If interference is experienced on 87.7MHz,change the position of the
frequency select switch on the face of the FM Stereo transmitter and
tune the radio to match the selected frequency.
FREQUENCY SELECTOR SWITCH
SPECIFICATIONS:
Frequency:87.7MHz to 88.9MHz(7channel-200KHz Step)
RF Output Level: 60dB
μ
M a x
S/N Ratio: 65dB
Stereo Separation: 40dB
FM Modulation Depth: 75KHz at L+R+Pilot
Operating Voltage:10V-16VDC
Dimensions: 33R*20.6mm
Weight: 48.2g
.Specifications and design are subject to change without notice
1
2
3
4
Frequency(MHz)
87.7MHz
87.9MHz
88.1MHz
88.3MHz
88.5MHz
88.7MHz
88.9MHz
