Valley Bender160, Руководство пользователя

Страница: 26 / 28

26
Maintenance
Belt Replacement
Replacement of the alignment belt requires a belt
and splice kit for the Bender160. If the belt shows
signs of damage or wear, contact your Valley dealer.
See Figure 26-1.
Hose Replacement
If the 6 in hose is sufficiently weather-cracked,
checked, or leaking, replace the hose. Follow the
steps below to replace the 6 in hose. See Figure 26-2.
1. Loosen the hose clamps. See Figure 26-2.
2. Remove the old hose.
3. Slide the hose clamps over the new hose.
NOTE
• To aid installation of the hose, a vegetable
based soap or tire bead lubricant may be
used to lubricate the barbed pipe. DO NOT
use oil, grease, or other petroleum-based
products.
4. Slide the new hose onto each stub pipe until the
hose contacts the hose stops.
5. Tighten the hose clamps. See Figure 26-2.
Contact your local Valley dealer if you have any
questions about replacing the 6 in hose.
Female Swivel Gasket Replace-
ment
Follow the steps below to replace the pierce gasket.
See Figure 26-3.
1. Remove the two 1/2 in bolts on the upper elbow
tabs connecting the upper elbow to the rotating
collar.
2. Lift the upper elbow assembly out of the rotating
collar and set aside.
3. Remove the old gasket and replace with a new
one ensuring the lip seal is pointing downward.
4. Gently push the inlet elbow back into the rotating
collar and align the bolt holes in the tabs.
5. Using the two 1/2 in bolts from before, bolt the
upper elbow to the rotating collar and torque the
nuts to 75 ft-lbs.
1
Figure 26-1 1. Alignment Belt
1
2
2
Figure 26-2 1. 6 in Hose
2. Adjustable Hose Clamps
1
Figure 26-3 1. Upper Elbow
2. Pierce Gasket
3. 1/2 In Hex Nut
4. 1/2 In Lock Washer
5. Rotating Collar
6. 1/2 Flat Washer
7. 1/2 In x 1/4 In Bolt
2
3
4
5 6
7