Valex TB26 FG, Руководство по эксплуатации

Страница: 9 / 12

- 9 -
g
! !
Before using this product read all the
enclosed safety instructions and instructions
for use.
Before operating the machine familiarise
yourself with the commands and with the
correct use of the machine, ensuring that you
are aware of how to switch it off in case of an
emergency. Improper use of the machine could
cause serious injury.
Always consider your safety and the safety
of others and act accordingly. Carefully keep
this instruction handbook in a safe and handy
place.
WARNING! The machine is only for cutting
grass in gardens and along the edges of flower
beds. Any other use not indicated in these
instructions can cause damage to the machine
and constitute a serious risk to the user.
ATTENTION! FOR D.I.Y. USE ONLY.
MACHINE DESCRIPTION (FIG. A)
1 Upper hand grip
2 Switch
3 Cable clip
4 Power supply plug
5 Central hand grip
6 Casing
7 Spool and spool cover
8 Air vents
9 Protection
10 Wire cutter
11 Cutting element
12 Locking screw (if present)
DESCRIPTION OF MARKS AND SYMBOLS (FIG.B)
1 Machine model
2 Technical data
3 Machine serial number and year of manu-
facture
4 Certification marks
5 Machine with double insulation
6 Electric and electronic waste may contain
substances that are dangerous for the
environment and for human health. For this
reason they must never be disposed of
together with domestic waste, but collected
separately in specific collection centres or
returned to the retailer when similar new
equipment has been purchased. The illegal
disposal of such equipment may result in
prosecution to the full extent of the law.
7 Noise level
STARTING UP (FIG.C)
WARNING! Before carrying out any checks or
maintenance operations, disconnect the plug
from the electric power supply.
WARNING! During this operation take care of the
wire cutter, as you could be injured.
The machine may be supplied with some loose
components. For their assembly, observe the
following instructions.
FITTING THE SAFETY DEVICES (Fig.C1)
WARNING! In the protection inner side is fixed
a razor blade which has the function to cut the
thread too long. Treat it with care and wear
protective gloves.
Place the guard on the bottom shell, positioning
the fixing wings in the appropriate joints. Turn
90° the protection to frame retainers (direction
of rotation according to the arrow in the figure).
Secure with the screw.
BODY ASSEMBLY (Fig.C2)
Insert the upper body and the lower body on the
central tube and fix each joint with 2 screws. Be
careful not to tangle the electric cable during
assembly.
CENTRAL HAND GRIP ASSEMBLY (Fig.C3)
Insert the handle into the body respecting the posi-
tion shown in the figure. Press fully until complete
coupling.
STARTING AND STOPPING
Before use, always check that the machine is in
good working order and check the length of the
trimmer line; check that the nylon line touches or
goes beyond the edge of the guard. If the nylon
line does not reach the required length, press the
button with one finger and at the same time pull
on the line (fig. D). For subsequent adjustments
when the machine is in use, gently tap the spool
button against the ground whilst continuing to
run the machine(fig. L). The length of the nylon
line will thus be automatically adjusted.