- 15 -
PROBLEMS, CAUSES AND SOLUTIONS
PROBLEM
CAUSES
SOLUTIONS
The electrical tool
fails to start
Battery empty
Fully charge the battery
Battery not correctly inserted in the
tool housing
Take out the battery and insert it correctly
Rotation direction switch in central lock
position
Move the switch to one of the two posi-
tions R or L
The battery has overheated and the
internal auto reset protection has cut in
Wait for the battery to cool down
Electrical tool or battery faulty
Replace the battery and/or contact an
authorised service centre
The battery does
not charge
Battery not correctly inserted in the
battery charger housing
Take out the battery and insert it correctly
Battery charger or battery not ready for
charging.
Battery overheated.
Wait for the battery to cool down
Battery charger or battery faulty
Replace the battery and/or contact an
authorised service centre
The drill stops whi-
le drilling
Battery empty
If available insert a new charged battery,
or take out the battery and fully charge it.
The battery has overheated and the
internal auto reset protection has cut in
Wait for the battery to cool down
!
!
IMPORTANT! If the electrical tool still fails to operate correctly after you have carried out
the above operations, or in the event of anomalies other than those described above, take it to
an authorised service centre with proof of purchase and ask for original spare parts. Always
provide the information shown on the technical data label.
WARRANTY
The product is protected by law against non-compliance with the declared characteristics provided
it is used only in the manner described in the instructions, it has not been tampered with in any
way, it has been stored properly, has been repaired by authorized and, where applicable, have
been used only original spare parts.
In the case of industrial or professional use or when using such a guarantee is valid for 12 months.
To issue a claim under warranty you must present proof of purchase to your dealer or authorized
service center.