VALERII S & M GROUP RTH122, Оригинальное руководство пользователя

Страница: 4 / 25

Проверил: Р.Ч./24.03.2015г

Avoid the anormal body moving, when operating the tools.

Avoid accidental starting. Ensure the switch is in the off position before plugging in.
Carry power tools with your finger on the switch or plugging in power tools that have the
switch on invites accidents.

Remove any adjusting key or wrench before turning the power tool on. A wrench or a key
left attached to a rotating part of the power tool may result in personal injury.
REPLACING THE GRINDING WHEEL
Before any work on the machine itself, pull the mains plug.
Use only wheels to min speed is as much as permitted no-load speed . Sanding and cutting
wheels are warming much during operating
Clean the grinding Wheel before fitting. Simple Wheel change by spindle lock: Press the spindle
lock and allow the grinding Wheel to latch in place.
Only ever press the spindle lock when the motor and grinding spindle are at a standstill.

Cutting Disc
Take care grinding discs sizes. Disc’s fitting hole’s diameter must be properly fitted to clamping
flange. Don’t use reduction parts and adapter . Take care matching of disc’s rotating direction
arrow and tool’s rotating direction arrow(rotating direction arrow is on head of tool).Put the
flange nut and tighten by special spanner.
Before operating, check the wheel if it is fitted correct and rotating easily.

Flap Sanding Disc
Take out the guard and fit hand security part. Put the clamping flange and disc to spindle.
Put the flange nut and tighten by special spanner.

Rubber Sanding Wheel
Take out the guard and fit hand security part. Before montaging the rubber sanding wheel, put 2x
discs.

Cup Brush/Wheel Brush