Valcourt FP10 Lafayette, Инструкция по установке и эксплуатации, Страница: 31 / 100

FP10 Lafayette - Installation and Operation Manual
31
It is recommended to clean thoroughly the chimney system at the end of every heating season. During
summer, the air is damper and with minimal air circulation within the stove or furnace, it can mix with
creosote and/or sooth deposits in the chimney system to form an acid that could accelerate the corrosion
process and induce premature decay of the steel. Corrosion damages are not covered under warranty. Have
your chimney system cleaned by a professional chimney sweep. Use a plastic or steel brush.
Contact your local municipal or provincial fire authority for information on how to handle a chimney fire.
Have a clearly understood plan to handle a chimney fire.
5.2.3 Cleaning the Chimney
Chimney cleaning can be a difficult and
dangerous job. If you don’t have
experience cleaning chimneys, you might
want to hire a professional chimney sweep
to clean and inspect the system for the
first time. After having seen the cleaning
process, you can decide if it is a job you
would like to take on.
The most common equipment used are
fibreglass rods with threaded fittings and
stiff plastic brushes. The brush is forced up
and down inside the chimney flue to scrub
off the creosote.
The chimney should be checked regularly
for creosote build ‐ up. Inspection and
cleaning of the chimney can be facilitated
by removing the baffle.
Do not expect chemical cleaners to keep
your chimney clean.
The rain cap can be removed for inspection and/or cleaning of the chimney.
The chimney should be swept following these steps:
1) Remove the fire baffle and air tubes.
2) Remove the rain cap.
3) Sweep the chimney.
4) Clean the inside of the firebox.
5) Re ‐ install the baffle, the air tubes and the rain cap.
CAUTION: OPERATION OF YOUR FP10 LAFAYETTE WITHOUT THE BAFFLE MAY CAUSE UNSAFE AND
HAZARDOUS TEMPERATURE CONDITIONS AND WILL VOID THE WARRANTY.