3
947752
Align the clock housing over the mounting bracket
flange and secure the clock housing to the flange with
eight screws provided (four each side). Confirm the
two screws at the opposite end of the center support
bracket are firmly tightened.
The Network Interface unit attaches to the center
support bracket inside the housing. Align the center
cable hole and two screw holes in the Network
Interface mounting plate with the predrilled holes in the
hanging rod and attach using two screws (included).
Feed the network cable from the mounting bracket into
the clock housing. Be careful to not damage the RJ45
connector on the cable.
Connect the network cable to the RJ45 jack on the
Network Interface in the housing.
Attach one 5-pin female Molex connector from the
Network Interface to the clock movement on the back
of the clock, then slide the clock onto the housing and
secure by tightening two screws on the housing.
Repeat this procedure for the other clock face.
Setup
Information specific to your application will need to be
programmed into the clock using a computer. The PC
used for programming should be connected to the
same subnet as the clock. Setup will be done using
the IP Solutions Setup Tool. Download the latest
version of the free IP Solutions Setup Tool from the
Valcom.com web site at www.valcom.com/vipsetuptool.
Figure 1. Assembly Diagram