Valcom VIP-9895-IC, Быстрый старт

Страница: 1 / 3

Issue 1
1 947538
VIP-9895-IC
InformaCast
®
Compliant
IP EMERGENCY WALL MOUNT CALL STATION
INTRODUCTION
The VIP-9895-IC IP Emergency Wall Mount Call
Station provides emergency communication to
any SIP telephone, InformaCast intercom or to a
Valcom IP Gateway. At the time of activation,
the high intensity blue LED changes from
beacon mode to flash mode. The LED will
continue to flash until the call is terminated.
SPECIFICATIONS
Features

Power over Ethernet (PoE) (802.3af)

Call button calls a SIP address InformaCast
intercom or any Valcom Gateway

Combination LED Beacon/Flasher

Network programmable for control and setup

Vandal and Tamper resistant

Stainless steel enclosure, brushed stainless
steel grille and hardware

Available in several standard color
combinations
Environment

Suitable for Indoor/Outdoor installations
Networking

10/100 Mbps Ethernet port

Manual or Dynamic Host Configuration
Protocol (DHCP) IP address setup
Dimensions/Weights

32.15” H x 9.9” W x 8.0” D
(81.66 cm x 25.1 cm x 20.3 cm)

Shipping weight: 39.75 lbs. (18.1kg)
Mounting

Surface mount
Power

PoE: 802.3af, class 3
Speaker Output

100dB@4’ on-axis

High efficiency design for
voice intelligibility
INSTALLATION
When removing or reinstalling security
screws, start screws by hand before
tightening with a hand or power driver tool.
If using a power driver, operate it at very low
speed to help prevent thread seizing.

Using security hex driver carefully remove
top and set aside with hardware.

Using the security hex driver, carefully
remove the front speaker panel. While
supporting the panel, unplug connector from
main circuit board at the top of the speaker
(“A” in photo). Loosen screws from relay
connector on the small circuit board
attached to the speaker housing, and
disconnect the two white wires from the relay
(“B” in photo). Set speaker panel and
hardware aside.

Install base using appropriate hardware, with
supplied (4) 1.5” neoprene washers between
base and mounting surface.

Connect earth ground to base (ground may
be connected using one of the mounting
screws).

Connect RJ45 from network to Ethernet jack
on main circuit board (“C” in photo). Power
over Ethernet (PoE) is required. If PoE is
not available from the switch, an inline power
injector will be required.