2
947565
INSTALLATION
Operation:
Provides talkback intercom via Network
connection to customer telephone system,
Syn-Apps Revolution server or other destination.
Interface to customer telephone system can be
via SIP registration, FXO port or FXS port
(additional equipment may be required). The
optional call button may be programmed to
initiate a call to one of the above telephone
system interfaces. When the call is answered, a
hands-free communications path is established
to the horn.
Mounting (Network Interface)
The VIP-148AL-SA Network Interface is designed
for wall or table mounting and must be within 100
meters of the network switch.
Mounting (Horn)
The VIP-148AL-SA Horn is designed for most FD
electrical box or wall mounting and must be within
300 meters of the VIP-148AL-SA Network
Interface. See NEMA OS 3-2002 sec.1.2.3.5 for
FD box specifications.
Attaching Speaker to Base
NOTE: For ease of installation, the base can be
attached to the speaker before or after the base
is mounted.
Loosen position adjustment knob
Insert the ball of the base into the socket of
the speaker
Tighten the position adjustment knob
These horns should be mounted 15 to 20 feet
above the floor to allow for best sound
distribution. The units can be mounted to a wall,
a beam or an electrical box.
A “C” clamp is provided with the horns to
allow mounting to a beam. When using the
“C” clamp for mounting, remove the signal
cable from the ball mount. Reinstall an RJ45
connector on the signal cable after mounting,
using the T568B pinout scheme.
See Figure 1.
The base has holes punched for a
double-gang square box, but by punching out
additional knockout holes, the base can be
mounted to a single-gang or octagon box
See Figure 2.
Mount the base to wall studs using the two
holes provided. Knockout holes are provided
for punch out should additional holes be
desired. See Figure 3.
The horns may be rotated or moved up and down
to obtain the desired position by loosening the
position adjustment knob at the bottom of the unit
approximately one turn. Make required
adjustments, retighten knob.
Figure 1. Mounting to
a Beam with a “C” Clamp
Figure 2. Mounting to an electrical Backbox
