5
Valcom, Inc.
5614 Hollins Road
Roanoke, VA 24019
USA
+1 540-563-2000 P.
+1 540-362-9800 F.
www.valcom.com
1.
Mount Housing to Wall and/or Gang Box -
To mount the housing to the wall, install two (2) wall anchors into the wall (not
supplied in kit) and take two pan head screws no larger than #8 (also not supplied in kit) and drive them into the anchors leaving
an 1/8th inch gap between the head of the screw and the wall. Mount the housing to the wall by lining up the two keyholes in the
back of the housing with the two screws with the 1/8 inch gap and slide the housing onto the heads of the screws. Next, mark the
2 mounting holes at the bottom of the housing on the wall. Remove the housing and install wall anchors at this location. Hang the
housing on the keyholes and install the bottom screws. To mount the housing to the gang box, take the four (4) 6-32 x 1” screws
(supplied in kit) and screw them through the four holes in the center of the inside of the housing and the four holes in the gang
box.
Note: If using a metal gang box, a ground must be provided to the gang box.
2. Feed Wiring Into the Housing -
Take the wire coming from the inside of the gang box and feed it through the hole in the
middle of the housing.
3.
Plug and Secure Wiring -
Loosen the provided wire clamp (comes attached to the inside of the housing) and slip excess wiring
through and tighten the clamp. After securing excess wiring, connect the wiring into the appropriate connector on the back of the
display board. (See the Wiring and Jumper Settings on page 9).
4.
Mount Display Board to Housing -
Using the four (4) self tapping, 6-19 x 1/2” flat head screws (supplied in the assembly kit),
take the display board and screw it to the front side of the clock housing (4 screws per clock).
5.
Snap on Filter -
Take the red filter bezel and snap it on to the front side of the housing.
6. Snap on Frame -
Take the gray frame and snap it on to the front side of the housing.
Surface (Wall) Mount Installation (continued)
Ins
tal
la
tio
n
