NOTE
: Before using your stroller, be sure to attach the tether straps around the stroller frame by feeding the strap through
the slit in the steel buckle. While not essential for safety, these help reduce the motion of the seat within the stroller frame.
Adjusting your seat – zip/belt System
(selected units)
In addition to the 4 adjustment
positions using the zip system, your
stroller has an additional 5
th
position
which raises the seat to an even more
upright sitting position.
1.
With all zippers fully closed, lift
the seat back further upward
with your hand.
2.
Secure the seat with the two
sets of straps (one at the top
and one at the bottom of the
seat back), inserting each
buckle into the corresponding
buckle housing in the matching
strap.
Your seat can be adjusted to 4 positions
using the zip system
1.
To recline, pull one of the zippers
located on the seat side downward.
2.
Do the same to the corresponding
zipper on the other side of the seat
3.
For more recline, release more
zippered sections.
4.
For seat incline simply reverse this
procedure.
BE SURE THAT ALL ZIPPERS ARE
OPENED/CLOSED FULLY BEFORE USE.
3.
Press down on the side locking
hinges (on the basket) to lock
the frame in the open position.
4.
Secure the handle to the
frame by engaging the locking
clamps on both sides.
NOTE: Special care must be taken
when adjusting the seat position with
a child in the stroller. Before adjusting
the zippers, place your hand beneath
the seat at its current position and lift
it slightly. This will relieve pressure on
the zippers and make them easier to
adjust.
“no zip” recline
(selected units)
Installing your hood
Using your brakes
There are two available brake
systems available for the Runabout
Tri Mode series:
STANDARD BRAKE (pictured)
1.
Press down on the centre of the
brake bar until the bar ends
engage in the nylon brake cogs
on the wheel.
2.
To disengage, lift the brake bar
upward till it locks in the upright
position.
CONCEALED BRAKE:
1.
Press the centre toggle down
firmly with your foot until you
feel the wheels have locked.
2.
To release, lift the centre toggle
from beneath with your foot.
1.
Place the plastic hood housings
over the corresponding housing on
either side of the stroller frame.
2.
Align the straight track on the
stroller housing with the
corresponding “hole” in the hood
housing.
3.
Slide the hood housing downward,
over the track, so that it
completely engages onto the
stroller frame.
The new “no zip” recline offers an
almost infinite amount of seat
adjustments:
1.
RECLINE: While squeezing the
centre release mechanism in a
pincer action, ease the seat down
to the desired position.
2.
INCLINE: Place your hand in the
centre of the rear of the seat.
3.
Pull the incline strap while gently
pushing on the rear of the seat
until the desired position has been
reached.
ALWAYS TEST that the seat is
securely locked in place.
IMPORTANT:
Always check that
the brake has fully engaged
IMPORTANT WARNING:
Always test that all axles, wheels, front bar, hinges and locks are securely engaged before use.
