Adjusting your seat
STANDARD MODEL
(not available in all markets)
NOTE
: Before using your stroller, be sure to attach the tether straps around the stroller frame by feeding the strap through
the slit in the steel buckle. While not essential for safety, these help reduce the motion of the seat within the stroller frame.
Adjusting your seat
DELUXE MODELS
(not available in all markets)
Your seat can be adjusted to 4 positions
using the zip system
1.
To recline, pull one of the zippers
located on the seat side downward.
2.
Do the same to the corresponding
zipper on the other side of the seat
3.
For more recline, release more
zippered sections.
4.
For seat incline simply reverse this
procedure.
BE SURE THAT ALL ZIPPERS ARE
OPENED/CLOSED FULLY BEFORE USE.
In addition to the 4 adjustment positions
using the zip system, your stroller has
an additional 5
th
position which raises
the seat to an even more upright sitting
position.
1.
With all zippers fully closed, lift
the seat back further upward
with your hand.
2.
Secure the seat with the two
sets of straps (one at the top
and one at the bottom of the
seat back), inserting each buckle
into the corresponding buckle
housing in the matching strap.
Installing your hood
3.
Press down on the side locking
hinges (on the basket) to lock
the frame in the open position.
4.
Secure the handle the frame
by engaging the locking clamps
on both sides.
NOTE:
Special care must be taken when
adjusting the seat position with a child in
the stroller. Before adjusting the zippers,
place your hand beneath the seat at its
current position and lift it sl ghtly. This
will relieve pressure on the zippers and
make them easier to ad
i
just.
Installing / Removing the front bar
( STANDARD System)
(DELUXE system)
1.
Open the flap in the fabric at either
side of the stroller and roll it
backward, securing to the side fabric
by aligning the 2 Velcro strips.
2.
Clip the shaped clamp onto the
inside of the stroller frame.
TIP:
Be sure that the red adjustment
button is on the top. If not press and
rotate the clamp until it is.
3.
Secure the bar to the strolle
r
frame
by engaging each locking clip in turn.
4.
Adjust the bar height by
simultaneously pressing the 2 red
buttons and swivelling the bar to the
desired position.
IMPORTANT WARNING:
The front bar IS
NOT a restraining device
1.
Open the flap in the fabric at either
side of the stroller and insert the
bar ends into the nylon housing
located on either side of the frame.
Be sure that the bar is securely
engaged
2.
Adjust the front bar by
simultaneously pressing the 2 red
buttons and swivelling the bar
(forward or backward) to the desired
position.
3.
To remove the front bar: Feeling the
side of the nylon housing that sits
below the frame at each side (facing
inward), locate the release “button.”
4.
Press the release button inward
while simultaneously pushing upward
on the bar housing. Repeat for the
other side.
1.
Using the screwdriver provided,
remove the screws and protective
covers from the tube.
2.
(a) ADJUSTABLE HANDLE MODEL:
Attach the hood fabric to the
frame using the rear zippers found
on the inseid of the hood at the
rear.
(b) STANDARD MODEL: Insert the
hood tube through the elastic loop
on either side of the hood
fabrics.The rear section of your
hood arrives pre-installed in the
frame with a spring loaded
securing bar. This needs to be
removed when removing your hood.
3.
Insert the hood tube end into each
corresponding holding tube and
secure each side with the original
screw.
IMPORTANT WARNING:
Always test that all latches are securely engaged before use.
