Thank you for purchasing a quality VALCO product. Due to our policy of continuous product
development, this model is constantly evolving. It is possible that some features or procedures
outlined here have changed since this document was written. If you are unsure of any procedure
outlined here please contact the store from which you purchased it to obtain the most up to date
information, or contact us via the internet. See relevant web contact addresses on the back page.
Assembling / Opening your stroller
Remove the stroller from the carton and dispose of all packaging immediately. The rear wheels, front bar and hood all need to
be installed prior to use.
1.
Release the frame locking strap
by simultaneously pressing the
two buckle sides in a pincer
motion.
1.
Lift the handle until you hear
the frame lock into the open
position.
Wheels and brakes
1.
Line up the rear wheel/brake
assembly so that the brake bar
is facing AWAY from the
stroller.
2.
Lift the rear assembly inserting
the frame tubes and continuing
until the assembly is securely
locked into place.
1.
line the rear wheel pin with the
rear axle housing
1.
Press down on the brake lever
to simultaneously engage the
brake in both wheels.
2.
To release, simply lift the lever
with you foot.
ALWAYS
test that the brakes are
fully engaged by pushing the stroller
forward and backward.
1.
Insert the wheel pin into the
housing.
2.
Release the wheel lock and insert
the heel as far as it can go.
ALWAYS
test that the wheel is secured
in the housing
Front wheel operation
The wheels on your RAD stroller can swivel through 360
0
or be fixed in
position:
1.
To fix your wheel in position, turn each dial lock so that the centre
line is VERTICAL.
2.
To release your locked wheel, turn each dial lock so that the centre
line is HORIZONTAL
ALWAYS
ensure that BOTH wheels are set to the same action.
IMPORTANT WARNING:
Always test that the wheels and/or brakes are securely engaged before use.
