VALBERG VAL-FH20.2, Инструкция по эксплуатации

Страница: 17 / 36

15 EN
Product usage
B
Before using the product
WARNING!
• Correctly connect the unit and do not leave it within the reach of unsupervised
children.
• It is normal for heaters to emit an odour and smoke when they are turned on
for the first time or have not been used for a certain period of time. This will
disappear after a short while.
• The heater must always be placed in an upright position on a horizontal surface.
• Place the heater on a stable, heat-resistant and non-combustible horizontal surface
that is at least 30 cm (sides and rear) and 50 cm (front) clear of objects such as walls,
furniture and curtains.
• Never place the heater below electrical sockets.
• The heater is suitable for use in a 10-15 m² space, such as a living room or office.
• Do not use the heater in a bathroom or near to a swimming pool or other body of water.
The heater must never become wet. Do not use the heater in wet or humid conditions.
• Direct the air outlet into the room so that the air can flow freely. Make sure the air inlets
are unobstructed. Do not cover the heater’s air inlet or outlet vents/grilles.
Operation
1. Fully unwind the power cable.
2. Check the heater’s rating plate for the correct voltage. Connect the plug to a mains socket
with a suitable voltage.
3. Turn the power dial to FAN (no heat, fan only), LOW heat or HIGH heat.
4. Turn the temperature dial clockwise towards the MAX mark until you hear a clicking sound,
the power indicator lights up and the fan or heater starts to work. Turn the temperature
dial up to increase the temperature when using the low or high heat mode.
5. Turn the temperature dial anticlockwise towards the MIN mark to decrease the heater
temperature.
6. To turn the heater off, turn the temperature dial anticlockwise as far as it can go ( MIN
position) and turn the power dial to the OFF position. Unplug the unit from the mains socket.
NOTE: When turning the temperature dial up in LOW or HIGH heat mode, the
power indicator will turn on and a click will sound to indicate that the thermostat
is starting to work, and the desired function is activated. Similarly, when turning
the temperature dial down in LOW or HIGH heat mode, the clicking sound will
indicate that the thermostat has been turned off (the power indicator will also
switch off) and the function has been deactivated.