VALBERG FBI 16S43 A XAD929C, Инструкция по эксплуатации, Страница: 8 / 108

12 13 EN EN
Using the appliance Using the appliance
B B
WARNING
A hose that attaches to a tap can burst if it is installed on
the same water line as the dishwasher. If your sink has
one, it is recommended that the hose be disconnected and
the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses out from storage compartment located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into
the sink, making sure to avoid bending or crimping it. The height of drain pipe must be less
than 300-1000 mm. The free end of the hose must not be immersed in water to avoid the
back flow of it.
WARNING
Please securely fix the drain hose in either position
A
or
position
B
A
B
Water Inlet
Mains Cable
Back of dishwasher
Drain Pipe
Drain hose
40 mm
300-1000 mm
Drain Pipe
Counter
How to drain excess water from hoses
If the connection to the drain pipe is positioned higher than 1000 mm, excess water may
remain in the drain hose. It will be necessary to drain excess water from the hose into a bowl
or suitable container that is held outside and lower than the sink.
Water outlet
• Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
• Ensure that the water drain hose is not kinked or squashed.