VALBERG FBI 14S40 B KAD929C, Инструкция по эксплуатации

Страница: 34 / 227

27 EN
Using the appliance
B
Display
6
Waning
Indicator
Rinse Aid
If the « » indicator is lit, it means the dishwasher is
low on dishwasher rinse aid and requires a refill.
Salt
If the « » indicator is lit, it means the dishwasher is
low on dishwasher salt and needs to be refilled.
Water Faucet
If the « » indicator is lit, it means the water faucet
closed.
7
Screen
To show the remaining program time and delay time,
error code etc.
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Open the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Rapid button for more
than 5 seconds to enter the water softener setting mode.
3. Press the Rapid button again to select the proper set according to your local environment,
the setting will change in the following sequence: H3->H4->H5->H6->H1->H2->H3;
4. Press the Power button to end the setting mode.