USER'S GUIDE____________________________________________________________________
110 _________________________________________________________________ M210704EN-F
FILT
Use FILT command to set the output filtering level.
FILT
[
xxx
]<cr>
where
xxx
=
OFF, ON, or EXT (default = ON)
Device Information
Use the display/keypad or the serial line to display the device
information.
Press the
INFO
button in the basic display to see the following
information:
- Current sensor operation (for example, AutoCal or Purge) in progress
- Present or past unacknowledged errors
- Device
information
- Current date and time (only shown if data logger module installed)
- Adjustment information fed by the user
- Measuring
settings
- Information on Purge settings
- Display Alarm settings
- Serial interface information
- Network settings and status of the LAN and WLAN interfaces
- Analog output information
- Relay output information
1103-064
Figure 67
Device Information on Display
