USER'S GUIDE____________________________________________________________________
56 __________________________________________________________________ M211372EN-B
When replacing the filter, handle the filter from the top of the filter body.
Inspect the sealing ring for damage (used with ISO and UNF threads
only), and replace it if necessary.
1109-001
Figure 21
Opening the Filter
1109-002
Figure 22
Filter Structure
where
1 = Sealing ring (use with UNF and ISO threads only)
2 = MPS1
multiparameter
sensor
3 = Stainless steel mesh filter (turn from top of the filter)
Replace the filter as follows:
1.
Grip the old filter from the top of the filter body using an 11 mm
socket wrench. Turn the filter counterclockwise until it is loose.
2.
Pull the filter straight out carefully -
do not damage the sensor
.
3.
Take the new filter, and insert it to the filter thread.
4.
Tighten the new filter by turning it clockwise with the 11 mm
socket wrench. Tighten to 5 Nm.