Installation
7
Emulation Mode Selection (SAT emulation)
SAT Emulation Mode programming steps:
@
Properly install this unit.
@
Put “Left” programming switch in “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches into their default position (both switches “UP”). Wait up to 30 seconds until
confirmation beep.
@
Put ignition switch into the “OFF” position. Wait at least 10 seconds.
@
Put ignition switch into “ACC” or “ON” position.
@
Check SoundLinQ3 for functionality, especially TEXT capabilities.
Mounting unit using Velcro fasteners
!
Velcro Fasteners are not included
!
VAIS Technology strongly recomand to ground unit to the car chassis for best results
NOTE
“Hard” Velcro Fastener
Carpet or car chassis
SoundLinQ3
“Soft” Velcro Fastener
1 2
ON
1 2
ON
Ignition into
“ACC” or “ON”
position
Both switches
“UP”
Ignition into
“OFF” position
up to 30 sec
Confirmation beep
(Red LED blinks)
Left switch
“DOWN”
Confirmation beep
(Red LED blinks)
up to 10 sec
