Installation
We strongly recommend that you install the unit in an easily accessible location, so you can later upgrade
the unit or re-program it in case of incorrect programming.
IMPORTANT
@
Gain access to the back of your vehicle’s Head Unit.
@
Find the same port as our Audio Harness (see
“Connecting SoundLinQ2 to head unit”
)
@
Disconnect the existing connector and plug in our Audio connector into this port, then plug female end of Audio
Harness to plug into your factory connector . In some vehicles Audio harness female connector is not used.
@
Plug the other end of Audio cable into designated port on this unit.
@
Connect XM Radio Receiver interface cable as shown in the picture. (see
“Connecting the units”
)
@
Setup proper Emulation Mode for the unit (see
“Emulation Mode Selection”
)
@
Turn the car on and check SoundLinQ2 functionality (especially Text capability) before the final assembly.
@
Please mount this unit in an easily accessible location for upgrading and re-programming purposes.
@
Secure the Head Unit in its original position.
Installation
Emulation Mode Selection (CD and MD changer emulation)
MD Changer Emulation Mode programming steps:
@
Properly install the unit.
@
Put both programming switches in the “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for a long beep followed by a few short beeps. This may take up to one minute.
@
Put ignition switch into the “OFF” position.
@
Return programming switches into their default positions (both switches “UP”). Wait at least 10 seconds.
@
Put ignition switch into the “ACC” or “ON” position.
@
Check SoundLinQ2 for functionality, especially TEXT capabilities.
CD Changer Emulation Mode programming steps:
@
Properly install the unit.
@
Put “Right” programming switch in the “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for a long beep followed by a few short beeps. This may take up to one minute.
@
Put ignition switch into the “OFF” position.
@
Return programming switches into their default positions (both switches “UP”). Wait at least 10 seconds.
@
Put ignition switch into the “ACC” or “ON” position.
@
Check SoundLinQ2 for functionality, especially TEXT capabilities.
!
Improper Emulation Mode setting may cause unit to be unrecognized by head unit.
!
By activating “CD or MD Changer Emulation Mode” you force the unit to find proper location in the vehicle
Audio/Video network.
IMPORTANT
6
Both
switches
“DOWN”
Ignition into
“ACC” or “ON”
position
Ignition into
“OFF” position
Both
switches
“UP”
Ignition into
“ACC” or “ON”
position
10 sec
Right
switch
“DOWN”
Ignition into
“ACC” or “ON”
position
Ignition into
“OFF” position
Ignition into
“ACC” or “ON”
position
10 sec
Both
switches
“UP”
