Vaillant VWL 57/5 IS, Инструкции по эксплуатации, установке и обслуживанию

Страница: 50 / 72

Appendix
48
Installation and maintenance instructions Hydraulic station 0020257319_02
Setting level Values Unit Increment, select, ex-
planation Factory setting Setting
Min. Max.
T.0.63 High pressure 0 42.5 bar (abs) 0.1
T.0.67 High-pressure switch Off On On, Off
T.0.85 Evaporation temperature -40 90
℃
0.1
T.0.86 Condensation temperature -40 70
℃
0.1
T.0.87 Overheating target value -40 90
K
0.1
T.0.88 Overheating actual value -40 90
K
0.1
to 20 K are normal op-
erating parameters
T.0.89 Subcooling target value -40 90
K
0.1
T.0.90 Subcooling actual value -40 90
K
0.1
T.0.93 Compressor speed 0 120 Rotation/s 1
T.0.123 Temperature switch:
Compressor outlet Off On On, Off
T.1.01 Building circuit pump
power 0 100 % 5, off Off
T.1.02 DHW prioritising diverter
valve Heating Domestic
hot water Heating, Domestic hot
water Heating
T.1.40 Flow temperature -40 90
℃
0.1
T.1.41 Return temperature -40 90
℃
0.1
T.1.42 Building circuit: Pressure 0 3 bar 0.1
T.1.43 Building circuit: Flow rate 0 4000 l/h 1
T.1.44 Cylinder temperature -40 90
℃
0.1
T.1.46 Lockout contact S20 Closed Open Closed, Open Closed
T.1.59 Capacitor outlet temperat-
ure -40 90
℃
0.1
T.1.69 Outdoor temperature -40 90
℃
0.1
T.1.70 System temperature -40 90
℃
0.1
T.1.71 DCF status Current value No DCF signal
Validate DCF signal
Valid DCF signal
T.1.72 Lockout contact S21 Closed Open Closed, Open Open
T.1.119 MO1 output Off On Off, On Off
T.1.124 Safety cut-out immersion
heater Closed Open Closed, Open Closed
T.1.125 MPI input Current value
T.1.126 MO2 output Off On Off, On Off
T.1.127 MO3 output Off On Off, On Off
Installer level
→
Configuration
→
Language Current language Languages available for
selection 02 English
Contact details
→
Telephone
number
Phone number 0
–
9
MO relay Fault signal
Ext. immersion heater
DHW 3WV
None
Compr.start heat. from
−
999 9 °min 1
−
60
Compr.start cool. from 0 999 °min 1 60
Compressor hyster. 3 15
K
Applies for heating
mode only:
1 7
1)
See the overview of fault codes: Fault lists are only available, and can only be deleted, if faults have occurred.