Vaillant EIWH mini VED Series, Инструкции по эксплуатации и монтажу, Страница: 5 / 12

eletronicVED pro series
5
Notes on the documentation 2
1 Inlet pipe
2 Flow sensor
3 Water resistence detection
4 Left side panel
5 Circuit board
6 Temperature controller 7 Outlet pipe
8 Outlet temperature
sensor
9 Right side panel
10 Heater strip
11 Heater body
Appliance type
VED E 6/1-P IN
VED E 6/1-B IN
2 Notes on the documentation
The following description is a general guide covering the
entire document.
Other information must be used in conjunction with this
operation and installation instructions.
We do not undertake any liability for damage caused by
non-compliance with these instructions.
Reference
When operating the water heater, be sure to notice all the
operating instructions attached to the other components of
the appliance.
These instructions are attached to the corresponding
appliance components.
2�1 Information storage
▶ Transfer the operation, installation instructions, all
references and necessary auxiliary tools to the appliance
users.
▶ Users are responsible for keeping them in order to use
instructions and auxiliary tools as required.
2�2 Scope of the instructions
This instructions are only applicable to appliance with the
following types:
Table 2.1 Appliance and type name
The types of the appliance please refer to the nameplates.
2�3 Appliance type
The type of appliance to install can be determined
according to technical data of the installation instructions.
The installation personnel will make the mark after the
installation work is finished.
3 Product description
3�1 Main components
3�1�1 miniVED plus series
(VED E 6/1-P IN)
Fig.3.1 miniVED plus series main components
Remark
3�1�2 miniVED pro series
(VED E 6/1-B IN)
Fig. 3.2 mini VED pro series main components
Reamrk
3�2 Product features
3�2�1 miniVED plus series
Temperature control: built-in constant temperature mode,
default temperature is 38℃.
The water heater includes anti-electric wall, which is fully
insulated and safe.
Appliance will automatically power off when outlet
temperature is over 80℃, dry burning and safe grounding
protection.
Water quality tester. When the appliance is switched on,
the inlet water resistance will be detected. If the water
resistance does not meet the requirements, the appliance
will stop and display E7.
3�2�2 miniVED pro series
Constant power design: build-in power constant mode,
adjust the temperature by adjusting water mixing tap.
Safety, energy saving, high efficiency, beauty and
convenience are the design objectives of this product.
The nickel gold heater designed by the patent is integrated
with the anti-electric wall, which is fully insulated and safe.
Over temperature protection (over 55℃, automatic power
cut, water heater no longer heating).
Anti-dry burning, safe grounding protection.
The build-in water quality test is used to test water quality.
After the appliance is switched on, the inlet water is
detected. When the water resistance does not meet the
1 Inlet pipe
2 Inlet temperature sensor
3 Flow sensor
4 Water resistence detection
5 Left side panel
6 Circuit board 7 temperature controller
8 Outlet pipe
9 Outlet temperature sensor
10 Right side panel
11 Heater strip
12 Eater body