Installation
16
ecoTEC plus installation and maintenance instructions 0020134823_01
4
4.5
Wall-mounting the boiler
a
Danger!
Risk of death if the load-bearing capacity
of the fixing elements used is insuffi-
cient!
If the fixing elements or wall do not have
sufficient load-bearing capacity, the boiler
can come loose and fall down. This may
also cause leaks in the gas line, which is
potentially fatal.
>
When installing the boiler, make sure that
the fixing elements have a sufficient
load-bearing capacity.
>
Check if the supplied fixing kit may be
used for the wall.
>
Check the quality of the wall.
>
If required, use individual stands from
the cascade programme which is availa-
ble as an accessory.
1
4.3 Wall-mounting the boiler
>
Fit the hanging bracket (
1
) to the wall using the rawl
plugs and screws provided with the unit.
>
Hang the boiler (
3
) on the hanging bracket from above
using the suspension bracket.
4.6
Removing/fitting the front casing
2
1
4.4 Removing the front casing
Removing the front casing
>
Undo the screw (
1
)
>
Push in both retaining clips (
2
) so that the front casing is
released.
>
Pull the front casing forwards at the bottom edge.
>
Lift the front casing upwards from the bracket.
Fitting the front casing
>
Place the front casing on the upper brackets.
>
Push the front casing onto the boiler until the retaining
clips (
2
) on the front casing snap into place. For support,
you can also pull the retaining clips (
2
) downwards at the
same time.
>
Secure the front casing by tightening the screw (
1
).
Содержание ECOTEC PLUS VU 80
