Vaillant 0010044426, Руководство по эксплуатации

Страница: 36 / 168

36
Installation and maintenance instructions 0020323586_00
1.3.5 Risk of death caused by improper
repair work
▶
If the power supply cable is damaged,
never replace this yourself.
▶
Contact the manufacturer, customer ser-
vice or a similarly qualified person.
1.3.6 Risk of a deadly electric shock if you
interfere with an electric component
that is connected to the low-voltage
network
▶
Disconnect the product from the power
supply.
▶
Secure the product against being switched
back on again.
▶
Check that the product is voltage-free.
▶
Completely disconnect the unit from the
voltage supply before you open it.
1.3.7 Risk of deadly electric shock if faults
or leaks occur
▶
Earth the product.
▶
If a fault occurs, use the partition that
is installed on-site (e.g. fuses or power
switches) to disconnect the product from
the power supply.
▶
In the event of a leak at the unit, close the
cold water supply immediately.
1.3.8 Risk of burns or scalding caused by
hot components
▶
Only carry out work on these components
once they have cooled down.
1.3.9 Risk of material damage caused by
using an unsuitable tool
▶
Use the correct tool.
1.3.10 Risk of material damage caused by
the product being under pressure
▶
Take the max. permissible water connec-
tion pressure into consideration.
1.3.11 Risk of material damage caused by
frost
▶
Do not install the product in rooms prone
to frost.
1.3.12 Risk of material damage if the
electrical specifications are not
observed
If the electrical specifications are not ob-
served, there is a risk of damage for the
product and a risk of fire.
▶
Permanently connect the product's hard-
wired power supply cable to the house
installation.
▶
Do not connect the product via the plug.
1.3.13 Qualification
Only qualified electricians may carry out the
electrical installation.
1.4 Electrical specifications
▶
Ensure that the nominal mains voltage
complies with the specifications on the
data plate.
▶
Ensure that the cable for the house install-
ation is connected to an electrical partition
with a contact gap of at least 3 mm (e.g.
fuse or power switch).
▶
Use a line with suitable dimensions to con-
nect the product to the protective con-
ductor.
▶
Install line protection.
1.5 Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, directives, ordinances and laws.